The Logitech G500s has been used for more than two years. Originally, he felt that his teammates were all caused by a 9.9-inch mouse. Later, when he entered the G500s, he discovered that, in fact, the gap between IQs and even the best keyboard and mouse cannot be compensated. Because the reason why the hand is big is not to choose a snake house, it is full of regrets now. The problem has not occurred for a few months when the G500s is taken home: The left button always has a sticky feeling, and it clicks twice but it does not affect it. The most pitfall is the use of this symptom, sometimes it is sometimes not, and sometimes it is good to shake it twice, so that I do not even know how to describe after the sale. Did not think that this drag is two years, and now the symptoms remain, seeing the warranty expires, I still want to find ways to solve ah, so pull out the box ready to look for sales, Yan Nima, I invoice it? Forget it, I do it yourself, isn't it changing the micro-motion? First of all, of course, the demolition of the demolition, take the foot pad is actually a technical job, the foot pad is double-sided adhesive up, if necessary, can use the hair dryer to heat blowing for a while, to ensure that the time to take more easily and easily, should not be violently opened, deformed The mat will affect the original silky smooth feel. After the foot pad is removed, four screw holes will be visible, plus one under the sticker, for a total of five. By the way, once the sticker is damaged, it cannot be restored and the warranty cannot be enjoyed. Please consider again and again. Remove the shell, you will find the inside is also connected to the cable, the cable is snap-type, carefully use the tweezers to pick up the white buckle, you can unplug the cable, the separation of the mouse shell and base. Take a look at the domestic Omron, each click can issue a crisp buzz, it is not a micro-motion problem, it does not appear to need to be removed, this pit double PCB board, and no suction gun, really want to get started In fact, I am not exactly the same. After many observations finally found the problem, this clip was crowded with the rectangular hole next to it! Right-click here is no problem. This quality is really catching chickens. The original starting price, can buy 30 more than 9.9 mouse, USB cable can be connected together around the computer desk 10 laps, LED Marquee flashed up enough to illuminate the entire room! Then remove, remove the 3 screws of the triangle, lightly press the arrow, and the left and right buttons are removed. There is no ping pong, nail file. At the same time, remind the little partner with a sickle, do not use too much force, a few clicks, the naked eye can see the clips and holes separated on the line. After completing the square hole, turn back and clean the burrs on the clips. Be sure to light and light. I think this clip is very fragile and a little harder can break the rhythm. After you finish, remember to scrape a little and leave no glare as an aspect of the craftsman's spirit. Then wipe it clean with a towel and test it until you have no card. Originally, you'll be ready to wipe out the WD40. ...... The final job is to assemble back, don't forget to line up the card, pad alignment groove, obsessive-compulsive disorder can try to use tweezers to gently repair the fragile stickers. Just took a look and saw that many people and I have the same problem, I wonder if it is a common problem in G500s, but the left mouse button obviously crowded with the base, I do not know how this mold is opened, but also for this reason, my problem It is not necessarily your problem. Please also carefully observe where it is stuck, polished or lubricated depending on the circumstances. All in all, the mouse is like a new life is still very happy, do not say, I'm going to revenge, this time, to see who dares to say that I am a pupil! Teaching magnets Y30, teaching Ferrite Magnet HU NAN YUBANG MAGNETIC MATERIAL CO.,LTD , https://www.ybmagnet.com
July 31, 2024